Polypropylene Build Plates for 3D Printers!

Mamorubot made these for us and they work great! ♥♥♥♥

PLEASE READ the sizes below to make sure you get the correct one for your machine or measure your bed if your machine is not listed. A tape measure is fine. Remember, there are 25.4 mm in 1 inch and 10 mm in 1 cm. 

Benefits

• Superior adhesion compared to glass. No tape or glue needed with PLA! Adhesion is improved with temperature so prints can be removed easier at room temperature.
• Compatible with PLA, ABS, and exotics (good up to 130℃).
• Easy to clean! Use alcohol or warm, soapy water. 
• Weight savings compared to 3mm glass (see chart below)

 Sizes

• Miscellaneous     205*205*3 mm
• CR-2020             220*220*3 mm
• CR-10/CR-10S   310*310*3 mm
• CR-X/10S PRO  310*320*3 mm
• CR-10-S4           410*410*3 mm
• CR-10-S5           510*510*3 mm
• CR-10-MINI        235*305*3 mm 
• Ender 2               165*165*3 mm
• Ender 3/4/5/CR-20 235*235*3 mm
• Tevo Tornado      370*310*3 mm (Holes are drilled like original surface)
• Formbot              410*410*3 mm
• Wanhao D9(300) 310*310*3 mm

How to use

1. Remove Glass and Install Polypropylene Build Plate using the same clips
2. Reset nozzle height (level the bed)
3. Wipe with alcohol or glass cleaner
4. Be sure to set your first layer speed to 20-30 mm/sec

Bed Temperature Suggestions

1. PLA 50-70°C
2. Flexibles 50-70°C
3. ABS  100-125°C (110°C is suggested )
4. PC 100-130°C (120°C is suggested)
5. Nylon 90-120°C (110°C is suggested)
6. PP 100-130°C (120°C is suggested)
7. PETG 65-75°C

Weights

Happy Printing!