This is a resource page for the Formbot/Vivedino T REX 3
- This is a good starting point. Let us know how you like it! Here is some great info on Simplify3D operation
- You should use our resources folder but instructions are found on the github page for the Creawsome Mod
Firmware (current as of 4/29/19)
BE SURE TO DOUBLE CHECK YOUR Z-OFFSET BEFORE FLASHING AND SET TO YOUR OLD VALUE AFTER FLASHING!
ALWAYS RESET THE EEPROM AFTER A FIRMWARE FLASH AS WELL
Baud Rate is 250000
Older Firmware (if you want to revert)